Table of Contents
Advertisement
3
Make sure the SCSI ID No. of the scanner is 2 (default
setting).
•
If other devices are connected to the computer, make sure that
each SCSI device has a different ID No.
•
To change the scanner's ID No., use the ID No. switches (#1, #2,
#3) located on the back of the scanner. See Table 1 on
4a
If the scanner is the last device, set its terminator switch
(#4) to ON. Go to step 5.
4b
If the scanner is not the last device, make sure the
terminator switch (#4) is set to OFF (default setting).
5
Connect the power cord to the scanner's AC inlet and to
an AC outlet.
AC outlet
Power cord
1
2
3
4
ON
AC inlet
Setup
page
66.
63
Advertisement
Table of Contents
