Panasonic KX-PS8100 Operating Instructions Manual page 174

Color Calibration
174
To perform Bias Adjustment:
1a
If you wish to adjust the density for all colors
simultaneously, perform the following, then go to
1) Repeat steps 1 through 3 in
calibration page:" on page
"Calibration Offset" is displayed in the printer LCD panel.
2) Press the ENTER button.
"0*" (–5 to 5) is displayed in the printer LCD panel.
3) Press the
darken/lighten all the colors.
To make the color density setting of the Color Calibration Page
darker or lighter by 1 level, increase or decrease a value of the
Calibration Offset by 3 by pressing the
⁄
/CANCEL button.
For example when Calibration Offset is 0:
•
If you wish to make the density setting darker by 1 level:
—Select 3 by pressing the
•
If you wish to make the density setting lighter by 1 level:
—Select –3 by pressing the
4) Press the ENTER button.
"CYAN" is displayed in the printer LCD panel.
5) Press the
"Calibration Test Print" is displayed in the printer LCD panel.
1b
If you wish to adjust the density for each color
independently, perform the following, then go to
1) Repeat steps 1 through 3 in "To print a color
calibration page".
2) Press the
"CYAN" is displayed in the printer LCD panel.
3) Press the ENTER button.
"0*" (–10 to 10) is displayed in the printer LCD panel.
"To print a color
171.
/CONTINUE or ⁄/CANCEL button to
/CONTINUE button 3 times.
⁄
/CANCEL button 3 times.
/CONTINUE button 4 times.
/CONTINUE button.
step 2.
/CONTINUE or
step 2.