Table of Contents
Advertisement
Setup
54
3
Separate the media guides to the approximate width of
the media.
4
Fan the media, and then tap it on a level surface to avoid
media jams or skewed printing.
Do not fan the transparency to avoid fingerprints.
5
Insert the media with the printing side up into the multi-
purpose tray.
The height of media should not exceed the limit mark on the left
guide, or it may cause a media jam.
When loading the recommended transparency (3M CG3710) in
the multi-purpose tray, loading it with the leading tape side facing
down and the taped end entering the printer first. (See the
illustration below.)
NOTE:
•
Do not use a ink jet transparency that may be wrapped around
the fuser roller and cause damage.
Taped side facing down
Advertisement
Table of Contents
