Table of Contents
Advertisement
Options
280
To install a SDRAM DIMM:
1
Unpack the SDRAM DIMM(s).
Do not touch the connector edge on the SDRAM DIMM.
2
Place the printer controller board on a stable surface.
3
Unlatch the lever on the side of the empty socket (J2 or
J3).
4
Ensure that the notches on the SDRAM DIMM are
aligned inside the empty socket.
5
a) Slide the SDRAM DIMM into the empty socket (J2 or
J3) at a 45-degree angle and push the DIMM into the
socket.
b) Snap the lever(s) into place.
6
Replace the printer controller board in the printer.
For instructions,
board" on page
Notch
b
see "Removing and replacing the printer controller
273.
SDRAM DIMM
a
Socket (J2 or J3)
Advertisement
Table of Contents
