Avoiding Damage To The Fixture; General Precautions; Avoiding Damage From Light Sources - GLP impression X5 Quick Start And Safety Manual

impression X5
www.glp.de

Avoiding damage to the fixture

Important! Follow the directions in this section carefully, or the fixture may suffer
damage that is not covered by the product warranty.

General precautions

Check that the head is unlocked and that the head will be free of any obstacles
through its full movement range before powering the fixture on.
Do not drop the fixture or expose it to mechanical stress.
Protect the LCD display and control panel from shocks, or they may suffer damage
that is not covered by the product warranty.
Do not lift or carry the fixture by the head. Carry the fixture by the yoke with the tilt
lock applied.
Do not expose the fixture to heat (from other lighting fixtures for example).
Clean optical components only as directed in this manual. Oils, solvents, and other
chemicals commonly used for cleaning can damage the lens coatings and surfaces.
Use only original spare parts. Do not make any structural modifications to the fixture
or you will void the product warranty.

Avoiding damage from light sources

Do not point the front of the fixture towards the sun or other strong light sources.
Strong light can cause internal damage to the fixture, melting components or
starting an internal fire within seconds.
Figure 1. Avoiding damage from light sources
Damage can occur whether the fixture is powered on or off. See Figure 1. Damage
can also occur if the light hits the front of the fixture at an angle: the fixture does not
need to be pointing directly at the sun or other light source.
To avoid problems from strong light sources:
● Do not expose the front of the fixture to sunlight or any other strong light source.
● In outdoor applications during daylight, make sure that the front face of the
fixture is shielded or points away from the sun, even when the fixture is not in use.
10 impression X5 Quick Start and Safety Manual Rev. 20220505-01