GLP impression X5 Quick Start And Safety Manual page 17

German Light Products
Make sure that the head will not collide with another fixture or any other object
when it moves through its full pan and tilt ranges.
Mounting directly with a rigging clamp
To suspend the impression X5 from a rigging truss or similar structure with the head
hanging vertically downwards only using a rigging clamp bolted directly to the
fixture:
Obtain a suitable half-coupler type rigging clamp.
See Figure 6. Pass an M10 grade 8.8 steel bolt
through the rigging clamp and check that the bolt
will protrude minimum 10 mm / 0.4 in. and
maximum 15 mm / 0.59 in. into the base of the fixture
when tightened.
See Figure 3. Fasten the bolt through the half-
coupler clamp and into the M10 threaded hole in the
fixture's baseplate so that the clamp is held securely.
Fasten the rigging clamp securely around a rigging
truss chord or similar bar.
Secure the fixture against clamp failure as described
in 'Securing the fixture with a safety cable' on page 15.
Make sure that the head will not collide with another fixture or any other object
when it moves through its full pan and tilt ranges.
Mounting with an omega bracket and rigging clamp
To suspend the impression X5 from a rigging truss or similar structure with the head
hanging vertically downwards only using an omega bracket and rigging clamp:
Obtain a suitable omega bracket with 89 mm center-to-center camlock fasteners
and a suitable rigging clamp. Bolt the rigging clamp to the omega bracket using
a suitable grade 8.8 minimum steel bolt and self-locking nut.
See Figure 3. Line up the two camlock quarter-turn pins in the omega bracket
with the camlock fastener points in the base of the fixture and turn both locking
levers a full 90° clockwise to lock the brackets to the fixture.
Fasten the rigging clamp securely around a rigging truss chord or similar bar.
Secure the fixture against clamp failure as described in 'Securing the fixture with
a safety cable' on page 15.
Make sure that the head will not collide with another fixture or any other object
when it moves through its full pan and tilt ranges.
impression X5 Quick Start and Safety Manual Rev. 20220505-01
®
impression X5
Figure 6. Min./max. bolt
protrusion into fixture
base (millimeters)
17