German Light Products
Mounting
The impression X5 may be rigged in any orientation or placed on a stable horizontal
surface. You must install a secondary attachment such as a safety cable and use the
hardware configuration described in this chapter.
Securing the fixture with a safety cable
In any location where the fixture can cause injury or damage
if it falls, secure it with a safety cable that is approved as a
secondary attachment for the weight of the fixture.
To secure the fixture with a safety cable:
See Figure 2. Pass the safety cable through one of the
two safety attachment eyelets (arrowed) in the base of
the fixture. If any type of floor stand or Omega Bracket is
installed on the fixture, do not use any part of these
accessories for safety cable attachment, or you will leave
the fixture unsecured.
Pass the safety cable through or around a secure
anchoring point such as the rigging truss or other
supporting structure and take up as much slack as
possible, then lock the safety cable closed.
Check that the safety cable will hold the fixture safely if a
primary attachment fails.
Fastener options in baseplate
See Figure 3. The fixture's baseplate has:
● one threaded hole in the center that accepts an M10 bolt or machine screw, and
● two mounting points that accept standard camlock quarter-turn fasteners with a
center-to-center distance of 89 mm (3.50 in.).
impression X5 Quick Start and Safety Manual Rev. 20220505-01
®
Figure 3. Mounting points in base
impression X5
Figure 2. Safety cable
attachment points
15