Mounting In Sideways Position; Securing The Fixture - GLP impression X4 Instruction Manual

2.2.3 Mounting in sideways Position

To operate the
additional mounting bar. This is fixed by two Camlock quick-release
connectors. Two half-couplers (clamps) are used to mount the bar to a
standard truss bar. This technique is necessary to cope with the torque
which accrues in this mounting position. In addition it allows a re-
positioning of the couplers to fit between two truss chords. Never use the
"Mounting in hanging position" technique described above to fasten the
fixture in the sideways position. A safe and sound installation can not be
assured in this way. In addition this can damage the fixture base.

2.3 Securing the Fixture

Regardless of the mounting method of the
a stipulated safety wire. Attach the safety wire through one of the two holes
provided on the base of the fixture and connect it to the primary support
structure. Pay attention to a safe and proper fastening. The safety cable must
comply with EN 60598-2-17 Section 17.6.6 and be capable of bearing a static
suspended load that is ten times the weight of the fixture and all installed
accessories.
GLP German Light Products GmbH
I M P R E S S I O N
I M P R E S S I O N
Half-coupler (clamp) 1
(Instruction version: 1.0) / from software version: 1.18/18/12/10/n
X 4 in a sideways position please use an
X 4
2x 90°
Half-coupler (clamp) 2
without mounting bar
I M P R E S S I O N
I M P R E S S I O N
X 4 you'll have to use
X 4
9