Fire Safety And Protection From Burns - GLP impression X5 Quick Start And Safety Manual

www.glp.de
● Use only a Neutrik powerCON TRUE1 cable connector for AC mains power input at
the fixture's MAINS IN connector. If the connector and its keys are not in perfect
condition, install a new TRUE1 connector on the cable following the instructions
available on the Neutrik website before connecting the cable to power. Send the
old connector for waste recycling.
● Use a power cable that is minimum 14 AWG or 1.5 mm
temperature-rated to suit the application. In the USA and Canada the cables must
be UL-listed, type SJT or equivalent. In the EU the cables must be type H05VV-F or
equivalent.
● Disconnect the fixture from power before attempting to replace the main fuse.
Replace the fuse with one of the specified type only (see the fixture's
specifications at the end of this manual).

Fire safety and protection from burns

● Do not operate the fixture if the ambient temperature exceeds 45° C (115° F).
● The hottest parts of the fixture's surface can reach up to 100° C (212° F) during
operation. Avoid contact by persons and materials. Do not install the fixture in a
location where there is a risk of accidental contact. Allow the fixture to cool for at
least 30 minutes before handling it.
● Keep the fixture well away from flammable materials.
● Do not illuminate surfaces within 1 m (40 in.) of the fixture. The light output from
the fixture is powerful enough to cause burns or fire in illuminated objects at
close range.
● Keep all combustible materials (e.g. fabric, wood, paper) at least 10 cm (4 in.) away
from the fixture.
● Ensure that there is free and unobstructed airflow around the fixture. Provide a
minimum clearance of 30 cm (12 in.) around fans and air vents.
● Do not place any optical components other than impression X5 accessories from
GLP onto the front of the fixture.
● Do not stick filters, masks or other materials onto the fixture. Do not block the
light output in any way. The front surface becomes hot during operation and can
melt or ignite objects that are in contact with the surface. Ensure that the front
surface is clean and unobstructed at all times in order to prevent a fire hazard and
damage to the fixture.
● The fixture's optical components can focus the sun's rays, creating a risk of fire
and damage. Do not expose the front of the fixture to sunlight or any other
intense light source, even from an angle.
6 impression X5 Quick Start and Safety Manual Rev. 20220505-01
impression X5
, minimum 16 A-rated and
2