Table of Contents
Advertisement
German Light Products
affiliated companies will take no responsibility for damage or injury resulting from
disregard for the information in the user documentation.
● Check the GLP website at www.glp.de and make sure that you have the latest
versions of the product's user documentation.
● Check the fixture software version indicated on page 2 of this User Manual and then
use the fixture's control panel to check the version installed in the fixture. If the
versions are not the same, the user manual may still cover the fixture, because
software updates do not always affect the use of the fixture. However, it is possible
that this User Manual does not match the fixture perfectly. Software release notes
can help clarify this question. You can consult software release notes and download
the correct version of this manual on the GLP website if necessary.
● Make both the Quick Start and Safety Manual and this User Manual available to all
persons who will install, operate or service the product. Save both documents for
future reference.
● If you have any questions about the safe operation of the product, please contact
an authorized GLP distributor (see list of distributors at www.glp.de).
● Use the product only as directed in this manual. Observe all markings in this manual
and on the product.
GLP Service and Support
Contact information for the nearest GLP Service and Support is available online at
www.glp.de/en/service, by email at info@glp.de, or by telephone at the following
numbers:
● GLP Germany: +49 (7248) 927 19-55
● GLP N. America: +1 818 767-8899
● GLP UK: +44 1392 690140
● GLP Asia: +852 (3151) 7730
● GLP Nordic: +46 737 57 11 40
Avoiding damage to the fixture
The Quick Start and Safety Manual contains important information that is intended to
help you avoid possible damage to the fixture from other light sources, during
transportation, etc. Read that information before storing, transporting or using the
fixture.
Powering the fixture off
When you power the fixture off, douse the lamp but leave power applied to the fixture
for 30 minutes before shutting down. This will allow cooling fans to cool down the fixture
evenly, avoiding hotspots that can weaken or damage the lamp.
If you douse the lamp, leave power applied and wait 5 minutes or until the HOT
message disappears from the display until you restrike it.
Hilghlander Wash User Manual
®
5
Advertisement
Table of Contents
