Operating On The Floor (Upright); Mounting In Hanging Or Sideways Position; Securing The Fixture; Alignment Of The Fixtures - GLP impression x4 bar Instruction Manual

4 x Camlock for bracket

2.2.1 Operating on the Floor (Upright)

The I M P R E S S I O
I M P R E S S I O
stable standing of the fixture. An additional securing is usually not required.
Please pay attention to an even and gripping surface.

2.2.2 Mounting in hanging or sideways position

To operate the I
I
dedicated bracket supplied with your fixture. It is fixed to the base of the fixture
with fasteners called Camlock quick-release connectors. Insert the four fasteners
and turn each 90° to lock them. Do the opposite to release them again.

2.3 Securing the Fixture

Regardless of the mounting method of the
use a stipulated safety wire. Attach the safety wire through the bracket on the
base of the fixture and connect it to the primary support structure. Pay attention to
a safe and proper fastening. The safety cable must comply with BGI 810-3 (EN
60598-2-17 Section 17.6.6) and be capable of bearing a static suspended load
that is ten times the weight of the fixture and all installed accessories.

2.4 Alignment of the Fixtures

For precise and easy alignment of multiple fixtures the
is equipped with alignment pins on the side.
To deploy them, simply loosen the screw shown below, push it to the side and
fix the screw again.
Insert the pins in the related holes of the next fixture.
Do the opposite to slide in the pins again after every usage to avoid any
damage or injuries that could be caused by them.
impression X4 BAR 10 manual (v1.1)
N X 4 B a r 1 0 is fitted with 4x solid rubber feet which allows a
N X 4 B a r 1 0
M P R E S S I O N X 4 B a
M P R E S S I O N X 4 B a
GLP  German Light Products GmbH
r 1 0 in a hanging position please use the
r 1 0
I M P R E S S I O N X
I M P R E S S I O N X
I M
I M
from software version: v0.26
4 B a r 1 0 you'll have to
4 B a r 1 0
P R E S S I O N X 4 B a r 1
P R E S S I O N X 4 B a r 1
0
0
7