Software Console
The Software Console is available to support X-ray exposure and position
parameter control on the NX workstation. It is displayed on the NX
workstation next to the NX application.
The Software Console is used to control the X-ray exposure settings.
The Software Console is used to adapt the parameters for automatic
positioning.
The Software Console contains the DR Detector Switch.
Figure 8: Software console controls for generator, X-ray modality, positioner,
tomosynthesis and system messages
Related Links
Software Console and Tube Head Display
Generator controls
X-ray modality controls
Positioning controls
Controls for digital tomosynthesis
System messages
on page 142
on page 157
on page 158
on page 173
on page 178
DR 600 | Introduction | 29
on page 124
3261K EN 20210708 0808