J6 Expansion Connector; Js Programmer Connector For Receiver; Display; Status Code - BFT PERSEO CBE 230.P SD Installation And User Manual

£1A
6. 5 - EXPANSION CONNECTOR

7. DISPLAY

At power-on the display shows the board type"[ dH'; then the FW release X.Y.Z, then the type of bollard (see table on chapter cap. 5),
and finally the status or error code.
O
The status (initial
The status code is shown on the first 2 digits.
0
!:Idle
02:Opening
OP
03: Opening limit switch reached
OY: Stop activated during opening
05:Closing
r,
05: Closing limit switch reached
LL
01: Stop activated during closing
8
A standard cycle, without errors, is always 2 -> 3 when opening, 5 -> 6 when closing
On the third digit and dot, additional information is shown:
Display
.ti.
.8._
www.BFTGateOpeners.com | (800) 878-7829 | Sales@BFTGateOpeners.com
I) or error code is always displayed except in programming menu or when a blocking error is present.
STATUS
UPS active, mains voltage failure
STOP signal active
"Termon" active
Photocell engaged
Control unit
IIJ
6.6

7 .1 STATUS CODE

OB: Stop due to photocell triggering
Ft
09: Opening after photocell triggering
10: Pause after photocell triggering
Hydraulic bollards only:
I
I: Stop due to a detected obstacle
Ob
12: Opening after a detected obstacle
13: Pause after obstacle detection
l'-1: Maximum working time in opening reached
tL
IS: Maximum working time in closing reached
- 28 -
PROGRAMMER CONNECTOR
FOR RECEIVER