Table of Contents
Advertisement
£1A
This solution is recommended when you want to allow entry to a reserved area, without using any commands, allowing transit of vehicles in
just one direction.
Loops S1 and S2 also have a safety function in thatthey will not let the bollard to move all the time if the vehide is over S1 or S2.
- Connect the
N.O.
- Connect the
N.O.
*
- The dimensional values given are only approximate.
We suggest installing the
PARAMETER
n,
CJ
II
www.BFTGateOpeners.com | (800) 878-7829 | Sales@BFTGateOpeners.com
INSTALLATION B
13.2
RECOMMENDED DIMENSIONS
contact of the coil receiver
to the
51
contact of the 52 loop receiver to the
"RME 2"
metal mass detector.
DATA
DESCRIP TION
[L
02
The close command acts as a close-when-released and safety function.
00
' I
Radio channel 1: Disabled
FP
01
Opening consent
LO
01
Semiautomatic logic
[P
00
Command during pause is OFF
Control unit
AUTOMATIC ENTRY OR EXIT
input.
OPEN
input.
CLOSE
- 38-
The vehicle approaches the
reserved area. When over the
loop
the bollard goes down.
51,
When the vehicle is no longer
over loop 52, the bollard will
rise again.
Advertisement
Table of Contents
