Table of Contents
Advertisement
3. TECHNICAL SPECIFICATIONS
- Power supply:
- Motor output:
- Flashing light/traffic light:
- Accessory output:
-Operating ambient temperature
4. INSTALLATION SAFETY
In order to reach the level of safety required by current regulations, read the following prescriptions carefully.
1) Make all connections in the terminal block after carefully reading the instructions given in this manual and observing the general
rules and technical standards governing electrical systems.
2) Upstream from the installation, fit an omnipole miniature circuit breaker with a contact gap of at least 3 mm.
3) If there isn't one already, install a residual current device with a threshold of 30 mA.
4) Check the effectiveness of the grounding system and connect to it all the parts of the automation fitted with a terminal or grounding
cable.
5) Fit at least one external warning device, such as a traffic light or flashing light, along with a warning or danger sign.
6) Fit all the safety devices required by the type of installation, taking into consideration the risks it can cause.
8
7) Separate the power lines (min. sect. 1.5 mm
5. PRELIMINARY OPERATION
- Before sending a command to the automation, make sure to have selected correctly the type of bollard as follows:
Bollard selection
- Hold down buttons F and + for 5 seconds to select the connected bollard.
- Select the type of bollard using the buttons +/-.
- Press F and + to confirm.
[,6
GB
PILLAR B 275/800 - XPASS B 275/800C
H6
HB
PILLAR B 275/800.6C SD - XPASS B 275/800C SD
H2
dS
dl
- Select network frequency through Ht parameter. (see 3rd level programming).
-
(Hydraulic bollards only) Select the pressure switch type with the parameter
- Check the connection method for simultaneous operation, if controlling multiple deterrent devices simultaneously (see paragraph 10).
6. INPUT AND OUTPUT FUNCTIONALITY AND CONNECTIONS
www.BFTGateOpeners.com | (800) 878-7829 | Sales@BFTGateOpeners.com
230Vac +-10%, 50/60Hz
230Vac; 13A max
230Vac; 40W max
24Vac; 1 A max
°
°
+60
C
-25
3.1 CONTROL PANEL DIMENSIONS
from the low-voltage signal lines (min. sect. 0.5 mm
2
)
PILLAR B 275/600
PILLAR B 275/600.6C SD
XPASS B 1200C
STOPPY MBB 219-500.C
STOPPY MBB 219-700.C
m
6.1
LINE
230V
230V 50/60Hz power supply with varistor internal protection and SA T (5x20) plus 16A T (6.3x32) fuses.
Connect the phase and neutral as shown on the screen printing. Use a cable type H07RN-F 2x1 .5+E min.
Connect the yellow/green wire of the power supply mains to the earth terminal of the appliance.
Control unit
-Operating ambient humidity
-Protection degree
-Storage ambient temperature
..,
�I
BOLLARD TABLE
ES
EASY 0115-500 - STOPPY B 115/500
El
EASY 0200-700 - STOPPY B 200/700
Fl
NOT AVAILABLE
I l
NOT AVAILABLE
[R
NOT AVAILABLE
[b
NOT AVAILABLE
PP (see 3rd level programming).
POWER TERMINAL BLOCK
- 25 -
up to 95%
non condensing
IP55
°
°
+60
C
-25
in the ducts.
2
)
oS
STOPPY 0210-500
ol
STOPPY 0210-700
us
NOT AVAILABLE
Ul
NOT AVAILABLE
[,2
NOT AVAILABLE
m
Advertisement
Table of Contents
