Table of Contents
Advertisement
£1A
Description of level 4 parameters
.con:
Setting communication protocol.
Set value always same to Master and Slave.
.uno:
Setting U-LINK mode.
.I.JI d:
Setting U-LINK adress.
9. RADIO RECEIVER
Use an antenna tuned to 433MHz. Con
nect the tuned antenna to the antenna
terminals using RG58 coaxial cable.
In the case of standard installations where no advanced functions are required, it is possible to proceed to manual
storage of the transmitters, making reference to programming table A and to the example for basic programming.
1) If you wish the transmitter to activate output 1, press pushbutton PRl, otherwise if you wish the
transmitter to activate output 2, press pushbutton PR2.
2) When LED DL 1 starts blinking, press "hidden key" on the transmitter, LED DL 1 will remain continuously lit.
3) Press the key of the transmitter to be memorized, LED DL 1 will flash quickly to indicate that it has been
memorized successfully. Flashing as normal will then be resumed.
4) To memorize another transmitter, repeat steps 2) and 3).
5) To exit memorizing mode, wait for the LED to go off completely or press the key of a remote control that
has just been memorized.
IMPORTANT NOTE: ATTACH THE ADHESIVE KEY LABEL TO THE FIRST MEMORISED TRANSMITTER (MASTER).
In the case of manual programming, the first transmitter assigns the key code to the receiver; this code is necessary
in order to carry out subsequent cloning of the radio transmitters.
This mode is used to copy the keys of a transmitter already stored in the receiver memory, without accessing
the receiver.
The first transmitter is to be memorised in manual mode (see paragraph 9.4).
a) Press hidden key on the transmitter already memorised.
b) Press key T on the transmitter already memorised, which is also to be attributed to the new transmitter.
c) Within 10 s., press "hidden key" on the new transmitter to be memorised.
d) Press key T to be attributed to the new transmitter.
e) To memorise another transmitter, repeat the procedure from step (c) within a maximum time of 1 O
seconds, otherwise the receiver exits the programming mode.
f ) To copy another key, repeat from step (a), having waited for the receiver to exit the programming mode
(or after disconnecting the receiver from the power supply).
www.BFTGateOpeners.com | (800) 878-7829 | Sales@BFTGateOpeners.com
9.1 RECEIVER TECHNICAL SPECIFICATIONS
°
- Max. n
of transmitters that can be memorized:
- Frequency:
- Code by means of:
°
- N
of combinations:
9.2 RADIO CHANNELS FUNCTIONALITY
Channel 1:
Select the command from parameter,.. 1- level 2
Channel 2:
Closes the relay contact on the terminal block J4: OUT4, OUTS,
if activated o'i= l'i - level 2, oS= l'i - level 2 (default).
9.3 ANTENNA INSTALLATION
9.4 MANUAL PROGRAMMING
9.5 SELF-LEARNING MODE PROGRAMMING
Control unit
.n:
d:
Setting Modbus/RTU ID.
.nSP:
Setting MODBUS RTU speed
.Err:
Show the list of error codes and the number of time they occur,
alternatively.
2048
433.92MHz
Rolling-code algorithm
4 billion
- 34 -
�
"Hidden key"
"Hidden key"
Advertisement
Table of Contents
