Table of Contents
Advertisement
£1A
This solution is recommended when you want to enter a reserved area in both directions. Entry is by means of a command while exiting is
automatic.
ENTRY
EXIT
Loops 51 and 52 also have a safety function in that they will not let the bollard to move all the time if the vehicle is over 51 or 52.
RECOMMENDED
DIMENSIONS
- Connect the contact of loop 51 receiver to PDM input.
- Connect the N.O. contact of the 52 loop receiver to OPEN
input.
*
- The dimensional values given are approximate.
We suggest installing the "RME 2" metal mass detector.
www.BFTGateOpeners.com | (800) 878-7829 | Sales@BFTGateOpeners.com
INSTALLATION D
13.4
Control unit
CONTROLLED ENTRY AND AUTOMATIC EXIT
:::::-,,
=--
�
-=SI
PARA METER
DATA
02
Lo
FP
OY
u,
CJ
02
II
r I
[P
DO
DO
[L
- 40 -
The vehicle approaches
the reserved area.
When the vehicle is over loop 51 the
bollard will go down only after a com
mand (ex.: remote control).
If the device is rising and the user
wants to lower it again, the vehicle
must be over loop 51 and the com
mand must be repeated.
When the vehicle leaves loop 52 the
bollard will rise automatically after an
adjustable pause time.
The vehicle approaches the reserved
area, when it is over the loop 52, the
bollard goes down.
DESCRIPTION
Functioning logic: Automatic
Special function
Radio channel 1: Open
Command during pause is OFF
Close standard
Advertisement
Table of Contents
