Table of Contents
Advertisement
TABLE A
�
� PR2 for CH2 output chanel
Programming
Automatic memory
storage only
trasmitter with
impulse output
Step-by-step
output
Timer output
Code elimination
Cancellation
of
the entire
receiver memory
LEGEND
FUNCTION
�
www.BFTGateOpeners.com | (800) 878-7829 | Sales@BFTGateOpeners.com
When pressing the key PR1 (for channel 1) or PR2 (for channel 2) for the first time, the receiver sets to the programming
mode. Every time the key PR is pressed after that, the receiver switches to the configuration for the subsequent function, that
is indicated by the number of flashings (see table).
At this stage, after selecting the channel (PR1 or PR2) and the desired function, the key T (T1-T2-T3 or T4) of the transmitter
will be stored in the memory of the receiver as indicated in the table for programming.
PR1
for CH1 output chanel
Constant blinking.
You will exit programming mode if no memorizing is performed
for 10 s.
2 blinks followed by a
pause of about 1 second.
The key T1 of the transmitter is automatically stored on the output
CH1 while the key T2 on CH2.
M tHi
3 blinks followed by a
pause of about 1 second.
N.D.
000080000.0 . . .
4 blinks followed by a
pause of about 1 second.
N.D.
5 blinks followed by a
pause of about 1 second.
N.D.
6 blinks followed by a pause
of about 1 second.
WARNING! This operation deletes all of the radiocontrols stored
on channel 1 and channel 2 from the memory of the receiver.
NUMBER OF LED DL 1 BLINKING SIGNALS
FUNCTION DESCRIPTION
Press the hidden key on the transmitter until the
LED remains
the transmitter until it starts flashing again, wait for the
LED to go off or switch off the power. The transmitter's
T key is now memorized.
Press the hidden key on the transmitter until the
LED remains lit, then press key T1 on the transmitter (if
other keys are pressed, they are ignored) until it starts
flashing again, wait for the LED to go off (10 s.) or
transmit a key to exit. T1 and T2 are now automatically
memorized on CH1 and CH2.
o
a
tHLn
. . .
While the LED is f lashing, keep buttons PR1 and PR2
on the receiver held down together for longer than 1 O
sec. The LED flashes very quickly.
By the time the LED goes off, all the transmitters are
deleted and you exit programming mode.
�
-35-
Standard Programming
lit,
then press the T key (1-2-3 or 4) on
Advanced Programming
Non-associated function
Non-associated function
Non-associated function
PROGRAMMING PROCEDURE
Advertisement
Table of Contents
