Table of Contents
Advertisement
Repair and Replacement Procedures
Removing and Replacing the A55 Solid State Drive (SSD)
Removing and Replacing the A55 Solid State Drive (SSD)
Certain unique files exist on the SSD that are necessary for proper operation of
your analyzer. These files must be copied to another location to allow them to
be installed onto the new SSD after it has been installed.
If you are replacing the SSD, the following procedure must be performed first.
Copy Unique Files from the Solid State Drive
— If installing an SSD for Windows XP: if the user has loaded unique
— If installing an SSD for Windows 7: for more information on the N8984A
— If installing an SSD for Windows 10: for more information on the N8985A
Tools Required
— T-10 TORX driver (set to 9 in-lb; for solid state drive replacement)
— ESD grounding wrist strap
Removal Procedure
Refer to
1. Disconnect the analyzer power cord.
2. Position the analyzer for access to the rear panel.
3. Loosen the SSD thumb screw (item
4. Pull the SSD out from the CPU assembly, using the handle (item
7-60
calibration kit information, navigate to C:\Program
Files\Keysight\Network Analyzer and copy USER_CALKITFILE to a
USB flash memory drive. Also copy any personal user files that you wish to
preserve.
Obsolete. Reference only.
SSD, refer to the Windows 7 Operating System Upgrade Kit Installation
Note, available online at
https://www.keysight.com/us/en/assets/9018-04311/installation-guides
/9018-04311.pdf
(N8984-90001).
Obsolete. Reference only.
SSD, refer to the Windows 10 Operating System Upgrade Kit Installation
Note, available online at
https://www.keysight.com/us/en/assets/9018-04733/installation-guides
/9018-04733.pdf
(N8985-90001).
Figure 7-30
for this procedure.
).
Keysight N5247B Service Guide
).
Advertisement
Table of Contents
Troubleshooting
