Returning And Replacing A U4164A Module Or Its Cables - Keysight Technologies U4164A Service Manual

Keysight U4164A Logic Analyzer
Service Guide
6 Returning and Replacing a
U4164A Module or its cables
To remove the U4164A module / 68
To remove the logic analyzer cable / 68
To install the logic analyzer cable / 68
To replace the circuit board / 69
To return the U4164A module or cable for Repair/Exchange / 70
This chapter contains the instructions for removing and replacing the U4164A logic analyzer module,
and the probe cables of the module as well as the instructions for returning defective parts to
Keysight Technologies.
Turn off the AXIe chassis before installing, removing, or replacing a module in the chassis.
CAUTION
The enclosure surface of the U4164A module may become hot during use. If you need to remove
the module, first power down the AXIe chassis, allow the module to cool, and then pull the module
out of the chassis.
Electrostatic discharge can damage electronic components. Use grounded wriststraps and mats
CAUTION
when performing any service to this module.