Keysight Technologies N5247B Service Manual page 57

Tests and Adjustments
System Verification
— Print Tabular Data: Prints the verification data in tabular form which
— Print Graphs: Prints the verification data in graphical form. The
— File Tabular Data: Writes the tabular data to a text file in the
— File Graphs: Saves a screen image in PNG format in the Windows XP
For printed output, it is assumed that the printer has been tested and the
Windows driver is installed for the printer that is being used. The system
verification test prints to the printer that has been designated as the
default printer. (On the Windows Desktop display, click on My Computer,
Control Panel, and then Printers to verify the printer setup.)
6. Click Run.
7. Follow the instructions on the analyzer for performing a full calibration or
recalling an existing recent calibration.
8. Follow the instructions on the analyzer for performing the system
verification; inserting the verification devices as prompted.
If the System Fails the Verification Test
Inspect all connections. Do not remove the cable from the analyzer test
port. This will invalidate the calibration that you performed earlier.
1. Disconnect and clean the device that failed the verification test.
2. Reconnect the device making sure that all connections are torqued to the
proper specifications.
3. Measure the device again.
Keysight N5247B Service Guide
includes measured data and uncertainty limits. For an example,
refer to Figure 3-12 on page
graphical form includes the measured data trace, factory supplied
data trace, and uncertainty limits. For an example, refer to
3-13 on page 3-31.
Windows XP directory
C:\Program Files\Keysight\Network Analyzer\Documents or the
Windows 7 directory
C:\Users\Public\Public Documents\Network
Analyzer\Documents\SysVer.
directory
C:\Program Files\Keysight\Network Analyzer\Documents or the
Windows 7 directory
C:\Users\Public\Public Documents\Network
Analyzer\Documents\SysVer.
To modify the number of ports to be verified or to change the
number of devices to measure, click on the Configure tab and make
the desired selections.
3-29.
Figure
3-27