Table of Contents
Advertisement
Chapter 2: Board Components
Configuration, Status, and Setup Elements
Table 2–13. Configuration Settings DIP Switch Controls (Part 2 of 2)
Configuration Scheme
JTAG – JTAG-based configuration
Notes to
Table
(1) ON indicates a setting of '0' while OFF indicates a setting of '1'.
(2) X indicates does not care. The JTAG-based configuration takes precedence over other configuration schemes and therefore, the FPGA_MSEL
pin settings are ignored.
Table 2–14. Configuration Settings DIP Switch Component Reference and Manufacturing Information
Board
Reference
S8
Table 2–15. Configuration Push-button Switches Component Reference and Manufacturing Information
Board Reference
S1-S3
© March 2010 Altera Corporation
Downloaded from
Elcodis.com
electronic components distributor
2–13:
Table 2–12
lists the configuration settings DIP switch component reference and
manufacturing information.
Description
Four-position slide DIP switch
Configuration Push-Button Switches
The PGM configure push-button switch, PGM_CONFIG (S1), is an input to the MAX II
CPLD EPM2210 System Controller. The push-button switch forces a reconfiguration
of the FPGA from flash memory. The location in the flash memory is based on the
PGM_LED[1:0] setting when the button is released. Valid settings include PGM_LED0
or PGM_LED1.
The PGM select push-button switch, PGM_SEL (S2), toggles the program LEDs (D3,
D4) sequence. Refer to
definitions.
The MAX II reset push-button switch, MAX_RESETn (S3), resets the MAX II CPLD
EPM2210 System Controller.
Table 2–15
lists the configuration push-button switches component reference and
manufacturing information.
Description
Push-button switches
(Note 1)
Setting
EPCS_nCS
FPGA_MSEL2
(S7.4)
(S7.3)
X
Manufacturer
Manufacturer
C & K Components
TDA04H0SB1
Table 2–8 on page 2–11
for the PGM_LED[1:0] sequence
Manufacturer
Manufacturer
Part Number
Panasonic
EVQPAC07K
Cyclone IV GX Transceiver Starter Board Reference Manual
FPGA_MSEL1
FPGA_MSEL0
(S7.2)
(S7.1)
(2)
Part Number
Manufacturer Website
www.ck-components.com
Manufacturer Website
www.panasonic.com/industrial/
2–15
POR
Delay
—
Advertisement
Table of Contents
