Status Elements; Setup Elements - Altera Cyclone IV GX Reference Manual

Chapter 2: Board Components
Configuration, Status, and Setup Elements

Status Elements

Table 2–9. Board-Specific LEDs
Board Reference
D1
D2
D3, D4
D12
D13
D14
D15
D16
D17
D18
Table 2–10. Board-Specific LEDs Component References and Manufacturing Information
Board Reference
D1
D2-D4, D13-D18
D12

Setup Elements

© March 2010 Altera Corporation
Downloaded from Elcodis.com electronic components distributor
The starter board includes status LEDs. This section describes the status elements.
Table 2–9 lists the LED board references, names, and functional descriptions.
LED Name
MAX_ERROR Red LED. Illuminates when the MAX II CPLD EPM2210 System Controller
fails to configure the FPGA. Driven by the MAX II CPLD EPM2210 System
Controller.
CONF_DONE_LED Green LED. Illuminates when the FPGA is successfully configured. Driven
by the MAX II CPLD EPM2210 System Controller.
PROGRAM Green LEDs. Illuminates to show the LED sequence that determines
(PGM_LED1,PGM_LED0) which flash memory image loads to the FPGA when PGM select
push-button switch is pressed. Driven by the MAX II CPLD EPM2210
System Controller.
Power Blue LED. Illuminates when 9-V – 16-V power is active.
USB_LED Green LED. Illuminates when the embedded USB-Blaster is in use to
program the FPGA. Driven by the MAX II CPLD EPM2210 System
Controller and MAX IIZ.
ENET_LEDR_TX Green LED. Illuminates to indicate Ethernet PHY transmit activity. Driven
by the Marvell 88E1111 PHY.
ENET_LEDR_RX Green LED. Illuminates to indicate Ethernet PHY receive activity. Driven
by the Marvell 88E1111 PHY.
ENET_LEDR_LINK1000 Green LED. Illuminates to indicate Ethernet linked at 1000 Mbps
connection speed. Driven by the Marvell 88E1111 PHY.
ENET_LEDR_LINK100 Green LED. Illuminates to indicate Ethernet linked at 100 Mbps
connection speed. Driven by the Marvell 88E1111 PHY.
ENET_LEDR_LINK10 Green LED. Illuminates to indicate Ethernet linked at 10 Mbps connection
speed. Driven by the Marvell 88E1111 PHY.
Table 2–10 lists the board-specific LEDs component references and manufacturing
information.
Description Manufacturer
Red LED Lumex, Inc.
Green LEDs Lumex, Inc.
Blue LED Lumex, Inc.
The starter board includes several different kinds of setup elements. This section
describes the following setup elements:
■ Board settings DIP switch
■ Configuration settings DIP switch
■ Configuration push-button switches
Description
Manufacturer Part Number
SML-LXT0805IW-TR
SML-LX1206GC-TR
SML-LX1206USBC-TR
Cyclone IV GX Transceiver Starter Board Reference Manual
2–13
Manufacturer Website
www.lumex.com
www.lumex.com
www.lumex.com