Presto CONTI COMPACT CC-20 V Operating Manual page 16

Safety
Fig. 3: sense of rotation motor
If the motor has the wrong sense of
rotation, switch the motor off immediately
and have a skilled electrician reconnect
two leads.
As no oil flows through the pump when
the motor rotates with the wrong sense,
the motor may be switched on only for a
very short time (5sec maximum).
Notes for cleaning, maintaining and
inspection works
Maintenance, cleaning and inspection
work may only be carried out by
authorised personnel and only when the
machine is at a standstill and switched off.
Cleaning flaps may only be opened for the
aforementioned purposes. The master
switch must be guarded by a padlock
against unintentional starting and must be
locked. Supervising staff or the appointed
skilled persons must keep the key at a safe
place.
Please find further necessary information
in chapter 7. After completion of the work,
all flaps have to be closed carefully.
Lead seals must not be broken nor
pressures be changed as this invalidates
any guarantee and may lead to
prosecution.
Separating protective devices held in place
by bolts which fit through keyhole‐shaped
slots are removed from the machine by
loosening the bolts 3 or 4 turns. The bolts
should remain in the drill holes. The cover
can now be slid along the keyhole and
removed by lifting over the bolt heads
which fit through the round, upper
keyhole aperture. The covers are replaced
by reversing the sequence.
The use of highly inflammable substances
(e.g. cleaning solvents) is prohibited.
Fig. 4: separating protective devices
Instructions on maintenance and repair
work
The instructions in the chapter
"Maintenance and repair" must be
observed.
04/2015 S. 16