Site Of Installation - Presto CONTI COMPACT CC-20 V Operating Manual

Safety
3.6 Site of installation
The site of installation has to be selected
according to the technical data in chapter
4. Weight, operational temperature and
ambient conditions of the machine have
to be respected.
If the machine is not installed on solid
ground, the operator must ensure that
any hydraulic oil escaping can be collected
in a drip‐tray.
The ground must be able to
support the load of machine
permanently. It must be possible to screw
the legs of the machine to the ground.
Fixing the machine to the ground is only
necessary if the bales are pushed for at
least 5 m. Use heavy duty plugs and
suitable screws for fixing the machine (see
enclosed project documentation).
The installation location has to secure that
no water or other liquids may reach
neither the bearing nor the motor. This
may lead to capital damages.
For installation and start‐up of the plant
the provisions of the water resources act
and the environment protection act must
be observed.
When operating the machine outdoors
without special precautions, weather
conditions can lead to malfunctions and
corrosion. If there is any danger of
ice formation or snow, when work
finishes or it is stopped for longer periods
(for instance, breaks during work) the
open loading funnel is covered with a
plastic sheet or panel.
Use of the equipment in spaces exposed
to an explosion hazard and in explosive
atmospheres is prohibited.
The plant may only be operated from a
mains supply which meets the
requirements stipulated in the chapter
"Electric system".
A fault current protective circuit in
accordance with VDE 0100 must be
installed as a protection against being
touched indirectly. The machine must not
be used if the mains supply cable is faulty.
The use of electrical coupling devices and
adapters for operating the channel baling
press is prohibited. Only plug‐in devices in
accordance with VDE 0165, par. 7.1.4 may
be used for connecting the machine.
Ensure that only staff ordered to do so
work on the machine. Keep away persons
not involved in the work process.
Take all precautions to ensure the safe
operation of the plant. (Lighting,
monitoring, access restriction, warning
signs...).
04/2015 S. 13