Troubleshooting - Scheppach SD1600V Translation Of Original Instruction Manual

15. Troubleshooting

WARNING
Always switch the machine off and remove the mains plug prior to all maintenance and cleaning work.
Fault Possible cause
Saw blade without Saw blade clamping screw (27/28) not
pins loosens after tightened enough
switching off the
engine
Motor does not start Mains fuse blown
Extension cable defective
Fine-wire fuse defective
Connection to the motor or switch not OK
Motor or switch faulty
Saw blades brake Tension set incorrectly
Load too high
Incorrect saw blade type
Workpiece not fed straightly
Saw blade oscillates, Holders not aligned
not aligned straightly.
30 | GB
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58
Remedy
Tighten the saw blade clamping screw (27/28)
Check mains fuse
Replace the extension lead
Check the fine-wire fuse and, if necessary,
replace it with a fine-wire fuse of the same type.
Have this checked by an electrician
Have this checked by an electrician
Set correct tension
Feed workpiece more slowly
Use correct saw blades
Avoid lateral pressure
Open the screws that fasten the holders. Bring
the holders into the vertical position and tighten
the screws again.