Troubleshooting - Scheppach HS100S Translation Of Original Instruction Manual

16. Troubleshooting

Problem Possible cause
Saw blade gets
loose after turning Fixing nut not tight enough
off the motor
Mains fuse blown
Extension cable defect
Motor does not start
Connections to the motor or switch
not OK
Motor or switch defective
Cross section of the extension cable
Motor not supplying
insufficient
power, fuse tripping
Overload due to blunt saw blade
Blunt saw blade
Burn areas at the
cutting surface
Wrong saw blade
Help
Tighten fixing nut with right-hand thread
Check the mains fuse
Replace the extension cable
Have it checked by an electrician
Have it checked by an electrician
See "Electrical Connection" in the operating
manual
Replace saw blade
Sharpen saw blade, replace
Replace saw blade
www.scheppach.com GB | 41