Troubleshooting - Scheppach HS115 Translation Of Original Instruction Manual

19. Troubleshooting

The following table shows fault symptoms and describes remedial measures in the event of your machine failing to
work properly. If you cannot localise and rectify the problem with this, please contact your service workshop.
Fault
Saw blade is loose after
the motor is switched off
Motor does not start
Motor not supplying power,
fuse tripping
Burnt areas on the cutting
surface
Incorrect motor rotational
direction
Direction of rotation
Possible cause
Fixing nut not tight enough
Mains fuse blown
Extension cable defective
Connection to the motor or
switch not OK
Motor or switch faulty
Cross section of the
extension cable insufficient
Overload due to blunt saw
blade
Blunt saw blade
Incorrect saw blade
Capacitor defective
Incorrect connection
www.scheppach.com
Remedy
Tighten fixing nut, right-hand thread
Check mains fuse
Replace the extension cable
Have this checked by an electrician
Have this checked by an electrician
see "Electrical connection"
Replacing the saw blade
Have an authorised sharpening service
sharpen the saw blade or replace it
Replace saw blade
Have this checked by an electrician
Have an electrician transpose the wall plug
poles
GB | 53