Table of Contents
Advertisement
H12 SX - HS3388 RT - H12 SXL - HS3388 RT XL - H15 SX - HS4388 RT - H15 SXL - H18 SX - HS5388 RT - H18 SXL
D
- Operation instructions
5.5 -
STORAGE
The machine can be stored in a designated area when not in use. If it has been stored for longer than 3
months without use then a periodic inspection must be conducted.
For engine storage condition follow engine supplier operator and maintenance manuals.
It is recommended that the machine is not stored or immobilized unfolded.
Ensure all access panels, doors and side compartment covers are shut and secured.
Turn the energizing key selector switch ( 72 ) at the ground control box to the "center" position
to shut OFF the power.
Remove the ignition key to prevent unauthorized operation of the machine.
Storing of the machine with an obstacle under the platform structure is forbidden.
To avoid any risk of corrosion on rods of cylinders during a storage period of more than 1 month :
• In a normal atmospheric environment : perform a complete cycle for the cylinders every 2 months while
they are in storage.
• In harsh environments (high levels of salinity in the atmosphere: close to the sea, industrial environment
with chloride emissions and/or humidity >70%), we recommend applying the following protection
process :
After washing the machine, make sure it is fully air-dry and does not contain moisture on corrosive parts
(cylinders rods for example).
Do not wash any electrical components, particularly with high pressure washer. Wipe away dirt from
around electrical components with a dry cloth.
5.6 -
LOADING BY RAMP
To avoid any risk of sliding during loading, ensure that :
• The loading ramp can bear the load.
• The loading ramp is correctly attached.
• The loading ramp has sufficient grip.
• The machine is completely stowed.
To climb the slope, select low driving speed
If the slope exceeds 25% grade, use a winch to assist in loading on to the ramp.
Never place yourself below or too close to the machine during loading.
A wrong move can lead to the tipping over of the machine and cause serious bodily and material accidents.
4001011590
• Wash and rinse the entire machine with plenty of clean water.
• Dry all the cylinder rods using an air gun.
• Apply a solvent-based oil leaving an oily film after evaporation of the solvent directly to
all rods left exposed when the machine is in storage position.
• Re-apply the product every month.
01.20
.
81
USA / GB
A
B
C
D
E
F
G
H
I
Advertisement
Table of Contents
