Storage - Haulotte Compact 8 Operator's Manual

Compact 8 - Compact 8CU - Compact 8W - Compact 10 (Compact 2747E) - Compact 10N (Compact 2632E) -
Compact 10N-1 - Compact 12 (Compact 3347E) - Compact 14 (Compact 3947E)
D
- Operation instructions
5.5 - S
TORAGE
The machine can be stored in a designated area when not in use. If it has been stored for longer than 3
months without use then a periodic inspection must be conducted.
It is recommended that the machine is not stored or immobilized unfolded.
Ensure all access panels, doors and side compartment covers are shut and secured.
Turn the energizing key selector switch ( 92 ) at the ground control box to the "center" position
to shut OFF the power.
Remove the energizing key to prevent unauthorized operation of the machine.
When machine is stored and not used for more than 1 week, check the battery's state of charge, recharge
if necessary.
To avoid any risk of corrosion on rods of cylinders during a storage period of more than 1 month :
• In a normal atmospheric environment : perform a complete cycle for the cylinders every 2 months while
they are in storage.
• In harsh environments (high levels of salinity in the atmosphere: close to the sea, industrial environment
with chloride emissions and/or humidity >70%), we recommend applying the following protection
process :
After washing the machine, make sure it is fully air-dry and does not contain moisture on corrosive parts
(cylinders rods for example).
Do not wash any electrical components, particularly with high pressure washer. Wipe away dirt from
around electrical components with a dry cloth.
90 4001182150
• Wash and rinse the entire machine with plenty of clean water.
• Dry all the cylinder rods using an air gun.
• Apply a solvent-based oil leaving an oily film after evaporation of the solvent
directly to all rods left exposed when the machine is in storage position.
• Re-apply the product every month.
E 08.21 USA / GB