Activation Of Controls; Fault Detector; Buzzers Test; Automatic Engine Cut-Out - Haulotte H12 SX Operator's Manual

H12 SX - HS3388 RT - H12 SXL - HS3388 RT XL - H15 SX - HS4388 RT - H15 SXL - H18 SX - HS5388 RT - H18 SXL
C
- Pre-operation inspection
4.2 -

ACTIVATION OF CONTROLS

The deadman foot pedal (enable switch) must be activated to allow any movement.
The "Enable Switch" system depends on the machine configuration and will consist of one of
the following :
• Joystick trigger at platform box (if fitted).
• Foot pedal (enable switch) in the platform.
• Enable switch at ground box.
4.3 -

FAULT DETECTOR

N.B.-:-The presence of this device depends on the machine configuration.
The fault indicator LED flashes to indicate a malfunction.
The machine switches to downgraded mode.
Certain movements can be limited or forbidden to preserve the operator's safety.

4.3.1 - Buzzers test

Step
1 Pull both E-Stop buttons ( 15 ) at ground box and ( 46 ) at platform box.
2 Select the upper console (72).
3 The indicator ( 31 ) at the platform control box lights up, and there is an audible signal (beep).
4.4 -

AUTOMATIC ENGINE CUT-OUT

The engine automatically cuts out in the following conditions :
• The alternatorand/or fan is no longer working.
• Engine temperature is too high.
• Oil pressure is too low.
• The air filter of the engine is clogged.
• The E-stop(s) is (are) pushed in.
62 4001011590
From the ground control box
Action
01.20 USA / GB