Table of Contents
Advertisement
H12 SX - HS3388 RT - H12 SXL - HS3388 RT XL - H15 SX - HS4388 RT - H15 SXL - H18 SX - HS5388 RT - H18 SXL
C
- Pre-operation inspection
4.5 -
OVERLOAD SENSING SYSTEM (ALL STANDARDS EXCEPT ANSI A92.6)
If the platform load exceeds the maximum allowed load, no movement is possible from the 2
control boxes.
At ground and platform control boxes a buzzer sounds and an indicator light warns the
operator.
To return the machine to normal operation remove weight from the platform until the load is
below the maximum allowed load.
Daily check that the LED's illuminate when the machine is switched on :
• Verify that the Overload system is active : Refer to Indicators ( 30 ) at ground and at platform.
• Verify that the buzzers are functioning : Refer to Buzzers test.
A periodic inspection of this device must be performed according to the recommendation in
Maintenance Schedule.
4.6 -
SLOPE WARNING DEVICE
From each control box, a buzzer alerts the operator that the machine is not folded/stowed and
is positioned on a slope exceeding the slope allowed.
When the unfolded machine is on a slope greater than the rated slope, out of the stowed
position, DRIVE and LIFT functions are disabled(All standards except ANSI 92.6).
All functions speeds are reduced.
In this case, fully lower the platform and reposition the machine on level ground before raising
the platform again.
N.B.-:-Depending on your machine configuration, outside assistance may be necessary in order to carry
out this operation.
Step
1
Pull the E-stop push-buttons on the platform and ground control boxes (15, 46).
2
Switch on the machine from the ground control box (72).
3
Start the engine from the ground control box with engine start-up selector ( 22 ).
4
Position the platform at a height of at least 3 m(9 ft10 in) using the lifting control ( 106 ).
5
Locate the tilt sensor next to the ground control box.
6
Manually tilt and maintain the tilt sensor towards the front for a few seconds (
7
Check that the audible beep sounds.
4001011590
To check the tilt sensor at ground control box
01.20
Action
USA / GB
Section B 3.1 - Layout).
63
A
B
C
D
E
F
G
H
I
Advertisement
Table of Contents
