System Storage; Sema® Board Management Controller; Debug Header; Boot Modes - ADLINK Technology SMARC NXP iMX 8M Series User Manual

Table of Contents

Advertisement

LEC-iMX8M plus User's Guide 1.0
SGET SMARC Rev 2.1
14x GPIO with interrupt

2.7 System Storage

SDIO
1x SDIO (4-bit) compatible up to version 3.0.
eMMC
Soldered on module 16, 32 or 64GB (build option) either standard or -40+85C temp range
Compatible with eMMC specification 4.41, 4.51 and 5.0
2.8
SEMA® Board Management Controller
Voltage/current monitoring, boot configuration, logistics and forensic
information, flat panel control, watchdog timer

2.9 Debug Header

30-pin multipurpose flat cable connector for use with optional DB-30 debug module Provides JTAG, BMC access; UART, power test points; diagnostic
LEDs, Power, Reset, Boot configuration

2.10 Boot Modes

eMMC and SD-Card boot modes are supported
Page 13
copyright © 2021 ADLINK Technology Inc.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the SMARC NXP iMX 8M Series and is the answer not in the manual?

Subscribe to Our Youtube Channel

This manual is also suitable for:

Smarc nxp lec-imx8mpSmarc nxp i.mx8m-plus quad npuSmarc nxp i.mx8m-plus quadSmarc nxp i.mx8m-plus quadliteLec-imx8m plus

Table of Contents