Heat Shield & Stand-Offs - Valor HORIZON 534JN Installation Manual

Appliance Preparation
Install Top Heat Shield & Stand-off s
1. If installing appliance with top vent outlet,
remove the plate covering the vent hole in the top
heat shield by unscrewing four screws. If installing
with rear vent outlet, the plate must remain to
cover the hole.
2. Remove the screws at the top rear corner of the
case sides.
3. If top vent outlet, locate the heat shield over the
vent pipe adapter.
4. Support the front of the shield on the two angle
supports.
5. Secure the shield to the case sides by refi tting the
two screws at the top rear corners and by two
screws from the pack fi tted near the front.
6. Bend the two top rear stand-off s and fi t to the heat
shield with three screws each.
NOTE
Zero clearance stand-offs and shield supplied with
the appliance are not required for the co-linear
applications.
Install Support Angles
The distance from the wall angles to the front face of
the heater case is adjustable between 3/8 inch and
1-3/16 inch to allow for a range of wall fi nish material
thickness (e.g. tile, etc.).
NOTE: When adding optional fronts and trims, it is
important to install heater fl ush or slightly recessed into
the fi nished wall surface.
1. Fit the top angle support to the case top (3 screws).
2. Fit the two side angle supports (2 screws each). Fit
the screws from inside the heater case.
Remove Rear Log Support
Remove the rear log support to access to the rear
orifi ces for restrictors installation (5 screws).
24
Heat Shield & Stand-offs
Shield to rest
on 2 supports
Heat shield
(shown for top vent outlet)
Wall finish material
thickness (tile, etc.)
3/8" - 1-3/16"
(10-30 mm)
Fit screws
from inside
case
Support angles
Remove rear support—logs only
Top & rear stand-off s