Valor HORIZON 534JN Installation Manual page 32

Installation
4. The underside of each ceramic rock is identifi ed
by a number and a specifi c protruding locating
triangle.
Install the six rocks from left to right starting
with rock no. 1.
Note that the ceramic base may need to be
slightly adjusted side-to-side to allow stones to
fi t within the platform.
A black discoloration may form over time at
the front bottom of the 6-rock original fuel
bed; this deposit can be burned off by running
the fi replace on a low to medium setting fi re
for 30 to 45 minutes. This discoloration is
unavoidable and will re-form again.
5. Place the glass panel in its cavity formed by the
front support and the ceramic platform.
6. Place the left twig across the sec-
ond and thirs rocks from the left;
rest its end on the glass near the
edge of the platform as shown.
Ensure to leave a gap between
the twig and the fi rst rock to allow fl ame to
come up between the twig and the rock.
7. Place the right twig across the
second and third rocks from the
right; rest its end on the glass
about 1 cm (13/32") from the edge
of the platform as shown. Ensure
to leave a gap between the twig and the fi rst
rock to allow fl ame to come up between the
twig and the rock.
32
Rock
identifi cation
Triangular
hole in
ceramic base
All rocks installed
Fuel Beds