How To Select The Source For Main Picture; How To Display The Pip Window; System Menu; How To Set The Auto Dimmer - Furuno MU-190 Operator's Manual

3. OPERATION
3.4

How to Select the Source for Main Picture

Select the signal to display on the entire screen as follows:
1. Press the DISP key to show the DISP selection window. The window shows
the signal names as you customized them at paragraph 2.4.2. This window
disappears if there is no operation for five seconds.
2. Press the or
[RGB]: Show the signal from the RGB port.
[DVI1], [DVI2]: Show the signal from the selected DVI port.
[VIDEO]: Show the external video from the VIDEO port.
3. Press the or
right top corner for five seconds after the DISP selection window disappears. If there is no sig-
nal, "NO SIGNAL" appears.
3.5

How to Display the PIP Window

The PIP (picture-in-picture) window, which displays the picture input to the VIDEO port, is avail-
able on the RGB, DVI1 and DVI2 displays.
1. With the RGB, DVI1 or DVI2 display shown, press the PIP key to show the PIP window. To
hide the PIP window, press the PIP key again.
2. You can move the PIP window by pressing the arrow keys when the menu is closed.
Note: You can adjust the size of the PIP window on the [VIDEO] menu (see section 2.3).
3.6

SYSTEM Menu

The [SYSTEM] menu controls the brilliance, clears the memory and shows signal status and pro-
gram number.
3.6.1

How to set the auto dimmer

The auto dimmer feature automatically adjusts the brilliance according to the ambient brightness
detected by the light sensor on the front panel. Also, you can select the interval at which the bril-
liance is adjusted.
Note: Do not put any objects in front of the light sensor.
1. Press the MENU key to show the menu.
key to select a signal.
key to close the window. The name of the selected signal appears at the
PIP window
21
RGB
DVI1
DVI2
VIDEO