Sumavision EMR3.0 Operating Instructions Manual page 265

12 ASI Output No Effective
Bitrate
13 G.703 Output No Effective
Bitrate
14 ASI Output Overflow
15 G.703 Output Overflow
«ТВБизнес» - официальный дистрибьютор
loop-back and set the valid
code rate of ASI input to be
50Mbps.
Reason: the multiplex
output is available on the
ASI output port, but no valid
audio and video code rates
are available.
Triggering: multiplex from
the input card 5 to ASI
output and pull up the input
of the input card 5.
Reason: the multiplex
output is available on the
DS3 output port, but no
valid audio and video code
rates are available.
Triggering: multiplex from
the input card 5 to DS3
output and pull up the input
of the input card 5.
Reason: the ASI output port
maps the multiplex DDR
overflow
Triggering: the multi-route
program is multiplexed to
the ASI output port when
the loop-back is switched on
such that the total valid
code rate of the program
exceeds the system code
rate set by the ASI output
port.
Reason: the DS3 output
port maps the multiplex
DDR overflow
Triggering: the multi-route
program is multiplexed to
the DS3 output port when
the loop-back is switched on
such that the total valid
code rate of the program
exceeds the system code
rate set by the DS3 output
port.
+7-812-600-25-77
mode.
Check whether
program multiplexed to the
ASI output exists. If not,
this multiplex shall
deleted or the multiplex
shall be substituted by
other existing programs.
Check whether
program multiplexed to the
DS3 output exists. If not,
this multiplex shall
deleted or the multiplex
shall be substituted by
other existing programs.
Delete some multiplex
programs of ASI output port
Delete some multiplex
programs of DS3 output
port
TVBS.RU
the
be
the
be
265