Sumavision EMR3.0 Operating Instructions Manual page 103

＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝
The audio decoding type supported by the SD-ADEC Card requires
corresponding authorization support. It can be realized by purchasing the
authorization.
The authorization status is divided into "EAC3, HEAAC", "HEAAC" or "AC3",
which support "All Audio Types", "AAC Audio" or "Dolby Audio", respectively.
＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝
When the SD-ADEC Card is used for decoding, it shall multiplex the program to be
decoded in the multiplex interface to the output port of the SD-ADEC Card at first. For the
program multiplex method, refer to section 5.1.1.2Multiplexing Setting. The introduction to
board card parameter setting is as below:
1
Step 1: click the "port n" in the "SD-ADEC Card" of WEB network management to log
in the port setting page;
Step 2: click the "Config" on the page to log in the port setting page;
Step 3: click the "Decode" switch on the page to be "On" and select the Error Handle"
and the "Sync Mode";
Step 4: set the "Service" and choose corresponding program or "Custom". When the
«ТВБизнес» - официальный дистрибьютор
2
6
Fig. 5-75 SD-ADEC Card Port Parameter Config
+7-812-600-25-77
3
4
5
TVBS.RU 103