Sumavision EMR3.0 Operating Instructions Manual page 144

Step 5: click the "Service" on the page to log in the program setting page;
Step 6: set the "Service Type" of corresponding program to be "SD" or "HD";
Step 7: set the program "Output Mode" to be "Bypass", "Statistic Multiplex" or "CBR"
according to the real application situation;
"Bypass": no treatment is made to the program and the direct output is made as per
as the original code rate.
"Statistic Multiplex": the adjustment is made to the code rate according to
corresponding priority, maximum code rate and minimum code rate setting and then the
output is made.
"CBR": the output is made according to the fixed code rate setting.
Step 8: set the program "Priority" based on the importance degree of program. The
"Priority" can be divided into five levels, including the "High", "Higher", "Middle", "Lower"
and "Low".
Step 9: set the code rate parameter according to the output mode selected for the
program. When the "Statistic Multiplex" mode is selected, set the "Minimum Bitrate" and
the "Maximum Bitrate" to limit the code rate fluctuation rage. When the "CBR" mode is
selected, set the "CBR" Bitrate value to output the program as per as the code rate setting.
«ТВБизнес» - официальный дистрибьютор
5
6 7
Fig. 5-119 StatMux4 Card Service Setting
+7-812-600-25-77
11
8 9
TVBS.RU
10
144