Warning List Of Asi 5Inout Card - Sumavision EMR3.0 Operating Instructions Manual

5 Output Overflow

4. Warning list of ASI 5InOut Card

Warning display
1 FPGA Configuration Failure
2 FPGA No Response
3 SMPTE310
Oscillator Abnormal
«ТВБизнес» - официальный дистрибьютор
cut off.
Reason: the data from the
back board to the port
exceeds the code rate
setting of
system that the overflow is
caused in
buffering area.
Triggering: the code rate
of output
excessively low.
Warning reason/triggering
condition
Reason: failed
configuration of daughter
card
Triggering condition: FTP
fails to upload the correct
FPGA configuration file.
Reason:
1) FPGA
fails and
operation of daughter card
is wrong;
2) The
operation is abnormal. If
the restart is invalid, the
hardware may fail.
Triggering: it is detected
that the status register of
the daughter card logic is
abnormal.
Crystal
Reason: the SMPTE310
function is available on the
card 355,
dedicated
crystal oscillator is not
welded.
Triggering:
dedicated
crystal oscillator which is
welded on the card 355
and choose
+7-812-600-25-77
program stream shall be
replaced. If the program
code rate is excessively
low (less than 200K), the
warning may be given.
Check whether the code
rate of the output system is
almost identical to the valid
the output code rate and change the
code rate of the output
the output system to be the maximum
value.
system is
Resolution
logic Replace the correct logical
configuration
restart the equipment.
1) Replace
logical configuration file. It
configuration
is unnecessary to restart
the logical
the equipment.
2) Return and repair of
equipment
equipment
Weld
crystal oscillator on the
but the card 355.
SMPTE310
remove the
SMPTE310
the
file and
the correct
the SMPTE310
TVBS.RU 260