Sumavision EMR3.0 Operating Instructions Manual page 106

5.3.15.2.1 CAM descrambling setting
When the CA scrambling program is found in the received program, it can set the
descrambling information in the "CAM Setting" page. After the de-scrambling, the
clear-stream program is the multiplex output. For the program multiplex method, refer to
section 5.1.1.2Multiplexing Setting.
Step 1: click WEB network management "Descramble Card" to log in the board card
setting page;
Step 2: click the "CAM Config" on the page to log in the CAM setting page;
Step 3: choose "On" in the "CAM Descramble Switch; choose the "CAM CLK"
according to the demand. Choose "On" via the Alarm switch of CAM card and set the
CAPMT interval of CAM card.
Step 4: click the "Apply" on the page after setting the parameter to put the setting
parameter into effect.
When the CAM card is inserted on the board card, the CAM information page will
show the CAS_ID of corresponding card.
«ТВБизнес» - официальный дистрибьютор
2
1
Fig. 5-78 Descramble Card CAM Config
4
+7-812-600-25-77
3
TVBS.RU 106