Adjusting The Front Wheel Toe-In - Toro 41393 Operator's Manual

Adjusting the Front Wheel
Toe-in
Service Interval: Every 200 hours/Yearly (whichever
comes first)
The toe-in should be 0 to 3 mm (0 to 1/8 inch).
1. Check and fill all tires; refer to
Pressure (page 36).
2. Measure the distance between both of the front
tires at the axle height at both the front and rear
of the front tires (Figure
Note:
The distance between the front of the
tires should be 0 to 3 mm (0 to 1/8 inch) less
than the distance between the back side of the
front tires.
Figure 83
1. Tire center line—back
2. Tire center line—front
3. If the measurement does not fall within the
specified range, loosen the jam nuts at both
ends of the tie rod
Figure 84
1. Jam nut
4. Rotate the tie rod to move the front of the tire
inward or outward.
Checking the Tire
83).
3. Axle center line
(Figure 84).
2. Tie rod
5. Tighten the tie rod jam nuts when the adjustment
is correct.
6. Ensure that there is full travel of the steering
wheel in both directions.
g002247
g002248
65