Table of Contents
Advertisement
3. On the Alarm Reasons screen, select REQUIRED, OPTIONAL or
DISABLED. Refer to
Table 3
Note: The Alarm Reasons option is set to Disabled by default.
Table 3 Alarm Reasons options
Option
Description
Required After doing a user-initiated sample cycle, the user is required to enter
information about all alarms that happen during the cycle. Alarm
reasons must be defined in the Alarm Reasons screen. The user
cannot exit the Alarm History screen until a reason has been entered
for all alarms.
Optional
After doing a user-initiated sample cycle, the user is prompted to
enter information about all alarms that happen during the cycle. Alarm
reasons must be defined in the Alarm Reasons screen.
Disabled
The user is not prompted to enter information about alarms.
Set the Sample Comments option
To record user comments made during routine sampling, change the
Sample Comments setting. Only administrators, factory-level users or
users with System Settings permissions can change the Sample
Comments setting.
1. On the Counter Navigation screen, push SYSTEM.
2. Select Sample Comments.
3. Select an option in the field at the bottom of the screen.
Option
Description
Required
After each user-initiated sample cycle, the user must select
one of the preset sample comments from the sample
comment list or enter a new comment.
Required on
After each user-initiated sample cycle, the user must select
Alarm
one of the preset sample comments from the sample
comment list or enter a new comment if an alarm(s) occurred
during the sample cycle.
for more information.
Option
Description
Optional
After each user-initiated sample cycle, the user is asked if
they would like to enter a comment for the sample. The user
can then select one of the preset sample comments from the
sample comment list or enter a new comment.
Disabled
The user is not asked if they would like to enter a comment
(default)
for the sample after each user-initiated sample cycle.
4. To add comments to the comment list so they can be quickly
selected:
a. Select Add.
b. Use the keypad to enter a comment about a sample run.
c. Push Enter.
Set the user interface language
The user interface language can be changed at any time. A language
change will require a system restart.
1. On the Counter Navigation screen, push SYSTEM.
2. Select the Options and Accessories tab.
3. Select the Language field to show language options.
4. Select a language. Push
Manage units and alarms
Units and alarms are controlled on the Units and Alarms tab. Units are
set for temperature, air velocity, relative humidity and flow rate. The high
and low parameter for the flow rate alarm are also enabled and set in
this screen. The instrument can be set to work with the Vaisala HMP
probe. Preset alarm reasons are accessible from this screen.
Manage audible alarm settings
The Sounds tab lets the user select the sound and volume to confirm
user interface actions. Sounds that are used for other alarms (stop
errors, limit alarms and warnings) are selected in this tab.
1. On the Counter Navigation Screen, push SYSTEM.
2. Select the Sounds tab.
then OK to restart the instrument.
English 23
Advertisement
Table of Contents
