Setup for Ethernet communication
1. On the Counter Navigation screen, push NETWORK.
2. Select the Ethernet tab.
3. Configure these options:
• Select FX or Modbus protocol.
• Enter the Modbus port number.
• Enter the Configuration port number.
• Enter the IP address or select DHCP to let the network assign the
IP address.
• Enter the subnet mask address.
• Enter the gateway address.
Setup for wireless communication
1. On the Counter Navigation screen, push NETWORK.
2. Select the Wi-Fi Configuration tab.
3. Configure these options:
• Enter the Network name.
• Select the data rate.
• Select the network type: Ad hoc or infrastructure.
• Enable auto fallback as needed.
• Select the channel (Ad Hoc mode only).
• Check Enable Radio if needed.
• Select the country.
Set wireless security
1. On the Counter Navigation screen, push NETWORK.
2. Select the Wi-Fi Security tab.
3. Configure these options:
• Select the security type.
• Select the encryption type.
• Select the authentication type.
• Select the key type: Hex or Passphrase.
• Enter the key in the Key field and in the Retype Key field.
Configuration
About configuration
This section describes tasks that are usually done at the initial
commissioning stage. Other tasks are done as updates to the particle
counter are needed.
Note: If user passwords are set, the user must be logged in as an administrator to
configure the particle counter.
About Basic and Advanced operation
At startup, the user can set the operation mode to Basic or Advanced
settings.
Use the Basic mode to:
• Do all particle measurement functions
• Save run data in the buffer
Use the Advanced mode to:
• Export dialogs
• Measure air velocity
• Set analog alarms
• Set standards wizards and reports
• Backup, restore and restart
• Copy a configuration
• Set the network protocol (serial, Ethernet, Wi-Fi)
• Manage areas and locations
• Manage user counts and security
• Set user-configurable particle sizes
• Filter data
Set the operation mode at initial startup
To set the operation mode:
English 21