End Time Prompt; End Date Prompt; Duration Prompt; Log Time Prompt - GE DigitalFlow DF868 Programming Manual

END TIME Prompt

END DATE Prompt

DURATION Prompt

Logging Data
[F1]
12.Press to accept the displayed End Time or press
different end time. To select a specific time period for the log to
[F3]
run, press .
•
OK
If was selected, proceed to the
•
TIMED
If was selected, proceed to the
•
EDIT
If was selected, complete the steps below.
Note: The log
END TIME
five minutes. Failure to observe this restriction will result in
an error message.
[F1] AM
a. Press for or press
[ENT]
Hour and press
b. Enter the desired Minutes and press
range is 0 to 59.
c. Enter the desired Seconds and press
range is 0 to 59.
[F1]
13.Press to accept the displayed End Date or press
different end date. To end the log today, press
• OK TODAY
If or was selected, proceed to the
prompt.
•
Otherwise, complete the steps below.
a. Enter the desired Year and press
0 to 99.
b. Use the [←], [→] and
Month.
c. Enter the desired Day and press
1 to the number of days in the selected month (28, 29, 30 or
31). The program proceeds to step 15.
If a circular log was specified, the programming sequence continues
here after the log start time and/or start date is entered.
[F1]
14.Press and enter a log Duration in hours or press
a log duration in days. Press
END DATE
prompt.
LOG TIME
START TIME
must exceed the log
[F2] PM
for . Then, enter the desired
. The acceptable range is 1 to 12.
[ENT]
. The acceptable
[ENT]
. The acceptable
[F3]
[ENT]
. The acceptable range is
[F1]-[F4]
keys to select the desired
[ENT]
. The acceptable range is
[ENT]
, and go to step 16.
March 2008
[F2]
to enter a
prompt.
by at least
[F2]
to enter a
.
TIME INCREMENT
[F2]
and enter
3-5