GE DigitalFlow DF868 Programming Manual page 54

March 2008
Selecting Error Handling
(cont.)
The OPTN Option
1-46
3. The program asks for the Error-Handling Delay time, the number
of seconds before the meter reports than an error has occurred.
Use the numeric keys to enter the number of seconds, and press
[ENT].
The User Program automatically returns to the
prompt.
The Model DF868 has two built-in analog outputs, which are
Slot 0
assigned to . Also, a variety of option cards may be installed in
the six expansion slots. See Chapter 1, Installation, of the Startup
Guide for a complete description of the available option cards.
Note: For this discussion,
specific expansion slots
Refer to the menu map in Figure A-4 on page A-4, and complete the
following steps to setup and/or scale the Model DF868's analog
inputs and outputs:
GLOBAL
1. To enter the menu, press
I/O
2. To enter the submenu, press
3. At the I/O screen, press
4. Use the [←] and [→] and the
Slot Number. (Only those slots which contain an option card will
appear on the option bar.)
Note: If the number of a slot with an installed option card does not
appear, the card may not have been initialized or it may be
defective. Call the factory for assistance.
Proceed to the appropriate section for programming instructions
specific to the type of input or output selected above.
Slot x
will be used to reference any of the
(Slot 1 - Slot 6)
.
[F3]=GLOBL.
[F3]
=I/O.
[F2]=OPTN
.
[F1]-[F4]
keys to select the desired
Programming Site Data
Global I/O