GE DigitalFlow DF868 Programming Manual page 51

Entering Global System
Data (cont.)
Programming Site Data
[F1]-[F4]
6. Press to select the desired number of Decimal Digits
(digits to the right of the decimal point) in the volumetric flow rate
display.
7. Use the [←], [→] and
Units.
Note: The option bar above shows English units. If Metric units are
GLOBL
specified in the
The abbreviations and definitions of all the available totalizer units
are shown in Table 1-16 below. The choices shown on the option bar
in the prompt screen above are determined by the selections made at
the previous System Units prompt screen.
Table 1-16: Totalizer Units Options
English Totalizer Units
Gal - U.S. Gallons
MGAL - Mega U.S. gallons
3
ft - Cubic Feet
3
Mft - Mega Cubic Feet
BBL - Barrels
MBBL - Megabarrels
Acre-inches
Acre-feet
[F1]-[F4]
8. Press to select the desired number of Decimal Digits
(digits to the right of the decimal point) in the totalized flow
display.
If you did not select the Energy Option in the
the meter now returns to the initial
selected the Energy Option, the following additional prompts appear.
[F1]-[F4]
keys to select the desired Totalizer
menu, these will appear instead.
Metric Totalizer Units
L - Liters
ML - Megaliters
3
m - Cubic Meters
3
Mm - Mega Cubic Meters
BBL - Barrels
MBBL - Megabarrels
Channel SYSTEM
SYSTEM
prompt. But if you
March 2008
option,
1-43