GE DigitalFlow DF868 Programming Manual page 102

March 2008
Creating an ERROR Log
(cont.)
3-10
Table 3-2: Measurement Parameter Options
Option Bar Choice
=
[F1] VEL
=
[F2] VOLUM
=
[F3] +TOTL
=
[F4] -TOTL
→]
=
[ + [F1] MDOT*
→]
=
[ + [F2] +MASS*
→]
=
[ + [F3] -MASS*
→]
=
[ + [F4] POWER**
→] →]
=
[ + [ + [F1] +ENRG**
→] →]
=
[ + [ + [F2] -ENRG**
→] →]
=
[ + [ + [F3]
* Available only if "Mass Flow (static)?" = YES
** Available only if "Energy Option?" = YES
Refer to Chapter 3, Diagnostics, pages 3-2 to 3-4 of the Service
Manual for a discussion of the many parameters accessible via the
DIAG
option.
Note: The units assigned to the parameters in Table 3-2 above are
those selected in the User Program (
6. Use the [←], [→] and
to be logged. See Table 3-2 above for a list of the available
options.
7. Use the [←], [→] and
be logged. See Table 3-2 above for a list of the available options.
•
If you selected a totalized value for display, go to step 8.
•
If you did not, go to step 9.
8. At the Set Log Totals to 0? prompt, press
at their present value or press
YES
Choosing at this prompt only resets the log totals to zero and
has no effect on the meter totals.
Description
Flow Velocity
Volumetric Flow
Forward Totalized Volume Flow
Reverse Totalized Volume Flow
Mass Flow
Forward Totalized Mass Flow
Reverse Totalized Mass Flow
Energy Flow Power
Forward Energy Flow
Reverse Energy Flow
Diagnostic
DIAG
SYSTM
[F1]-[F4]
keys to select the second parameter
[F1]-[F4]
keys to select the third parameter to
[F1]
to leave the log totals
[F2]
to reset the log totals to zero.
submenu).
Logging Data