GE DigitalFlow DF868 Programming Manual page 72

March 2008
Activating Security (cont.)
Procedure Options
1-64
IMPORTANT:
Since the default password is printed in this manual,
a new password should be entered. If the password is
ever lost, contact the factory for assistance.
6. Enter the New Password and press
letters and numbers up to a total of 21 characters may be used as a
password.
Note: Keep in mind that the password may have to be entered
frequently from the keypad. A long and/or complex password
may soon become annoying to use.
7. Verify the New Password by entering it again and press
sure to record the new password in a safe place.
8. At the Lockout Level prompt, press
CLR LOG
and menus, or press
[PROG].
You have completed entering data in the Global Program. Continue
as follows:
•
To continue programming the meter, refer to the menu maps in
Appendix A and navigate to the desired menu. Then, proceed to
the appropriate section of this manual for instructions.
•
Global PROGRAM
To leave the
[EXIT]
twice and then press
programming changes will be discarded and you will be returned
to the data display.
• Global PROGRAM
To leave the
[EXIT]
press twice and then press
programming changes will be entered into the meter's memory,
and you will be returned to the data display.
[ENT]
. Any combination of
[F1]
to lock only the
[F2]
to lock all the keys except
and retain the previous settings, press
[F1] = NO SAVE
at the prompt. Any
and return to measurement mode,
[F2] = YES SAVE
at the
Programming Site Data
[ENT]
. Be
PROG, CAL,
prompt. Your