Entering Global Data - GE DigitalFlow DF868 Programming Manual

March 2008

Entering Global Data

1-38
GLOBL
The menu is used to enter information that is not specific to
one of the individual channels. Information programmed via this
menu is used to compute parameters such as the sum, difference or
average of the channel 1 and channel 2 signals. In addition, several
general system parameters may be entered in the
IMPORTANT:
When calculating the
from the
conflicting data entered in the
SYSTM
submenus is overridden.
The following submenus are included in the
• CLOCK
- used to enter the current date and time
• SYSTM
- used to specify the units of measure used in calculations
• I/O
- used to set up error handling and to configure analog inputs
and outputs
• COMM
- used to set up the serial communications port
•
KV/SS
- used to enter a kinematic viscosity/signal strength table
•
TmpKv
- used to enter a temperature vs. viscosity table
•
SECUR
- used to specify a programming access password.
[F3]=GLOBL
After selecting
following screen appears:
PROGRAM
Global PROGRAM
previous selection appears here
CLOCK SYSTM I/O
Based on the selection made above, proceed to the appropriate section
of this chapter for instructions. Refer to Figure A-4 on page A-4 and
Figure A-5 on page A-5, and remember to record all programming
data in Appendix B, Data Records.
GLOBL
SUM DIF
, or
GLOBL-SYSTM
submenu is used. Any
CH1-SYSTM
GLOBL
at the initial programming screen, the
Start ‰
Press the [←] and [→] keys and
a function key
the desired submenu. From this
screen, press
the initial User Program screen
shown on page 1-8.
COMM
Programming Site Data
menu.
AVE
readouts, data
CH2-
or
menu:
[F1]-[F4]
to select
[EXIT]
to return to